Thermo 3010 Series, Руководство по эксплуатации и техническому обслуживанию, Страница: 7 / 37

Model 3010 Incubator ________________________________________________________Installation and Start-Up
1 - 2
1.3 Operating the Control Panel
The Model 3010 water jacket incubator has six modes,
which allow incubator setup. The modes are as follows:
• Run is the default mode that the incubator will normally be
in during operation.
• Set Temp is used to enter system temperature setpoints for
incubator operation.
• Set Otemp is used to enter system overtemperature set-
points for incubator operation.
• Set CO2 is used to enter system CO
2
setpoints for incuba-
tor operation.
• Cal Temp is used to calibrate displayed chamber tempera-
ture.
• Cal CO2 is used to calibrate displayed percentage of CO
2
in the chamber.
Figure 1-2
Control Panel
1.2 Control Panel Keys, Displays and Indicators
A SILENCE - Silences the audible alarm.
B Alarm Indicators - Specific indicator flashes during an
alarm condition.
C MODE Select Switch - Used to select desired mode.
D Mode Indicator - Selected mode indicator lights.
Mode Select Indicators-
Run: Normal Operation
Set Temp: Set Temperature Setpoint
Set Otemp: Set Overtemperature Setpoint
Set CO2: Set CO
2
Control Setpoint
Cal Temp: Calibrate Displayed Temperature (Offset)
Cal CO2: Calibrate Displayed CO
2
Value (Offset)
E/G Up and Down Arrows: Increase or decrease parameter
values.
F Enter: Saves the value being changed.
H Heat Indicator: Lights when power is applied to the
heaters.
I Inject Indicator: Lights when gas is being injected into the
incubator.
J Displays: Displays chamber temperature, temperature set-
point or overtemperature setpoint
K Displays: Displays percentage of CO
2
in the chamber or
CO
2
setpoint