Thermo 3010 Series, Руководство по эксплуатации и техническому обслуживанию, Страница: 10 / 37

f. Installing the Shelves
1. Install the side ducts with the tabs facing into the center
of the chamber with their slots up. There are no right
side or left side ducts, simply rotate one of them to fit
the opposite side. Tilt the side ducts as they are placed in
the chamber so the tops fit into the top air duct, then
guide them into the vertical position. Figure 1-10 shows
the duct as it would be oriented for the right side of the
chamber.
2. Referring to Figure 1-10, note that there is no difference
between left and right side shelf channels.
3. Install the shelf channels by placing the channel’s rear
slot over the appropriate rear tab on the side duct. Pull
the shelf channel forward and engage the channel’s front
slot into the side duct’s appropriate forward tab. Refer to
Figure 1-11.
4. Figure 1-12 shows one of the
channels installed on the right
side duct.
g. Leveling the Unit
Check the unit for being level by placing a bubble-style
level on one of the shelves. Turn the hex nut on the leveler
counterclockwise to lengthen the leg, or clockwise to shorten it.
Level the unit front-to-back and left-to-right.
h. Connecting the Unit to Electrical Power
See the serial tag on the side of the unit for electrical speci-
fications, or refer to the electrical schematics included in this
manual.
Connect the incubator to a grounded dedicated
circuit only.
The power cord connector is the mains disconnect
device for the incubator. Position the unit so that
it can be easily disconnected.
Plug the provided power cord into the power inlet connec-
tor (See Figure 1-13) and into the grounded dedicated circuit.
Electrical Specifications: 115V, 50/60Hz, 3.6A, 1 PH, 2W
Model 3010 Incubator ________________________________________________________Installation and Start-Up
1 - 5
Figure 1-10
Figure 1-12
Figure 1-11
Figure 1-13,
Rear Panel View, showing all options