7
14. Place the exhaust vent filter into the holder attached
to the pneumatic motor lift (Figure 22).
Note:
A ladder
may be required to reach the exhaust vent filter holder.
16. Attach the top back BPC tabs to the pins on the top
back of the outer support container.
Note:
A ladder is
needed to reach the top back BPC tabs.
17. Guide all line sets on the bottom of the BPC through
the bottom cutout in the outer support container
(Figure 25).
Figure 20. Closing the gate
completely.
Figure 21. Pushing the metal pin
up to lock the gate.
Figure 19. Swinging the gate to
the right.
Metal pin
Figure 22. Securing the exhaust
vent filter to the holder.
15. While holding the front linesets to keep them from
tangling, use the motor lift controller (see the user’s
guide (DOC0090) for information on using the motor
lift controller) to raise the pneumatic motor lift (Figures
23 and 24). After raising the motor lift to its highest
position, turn the lock dial on the motor lift controller.
Note:
The controller cannot be locked unless the
motor lift has been fully raised.
Figure 23. Pneumatic motor lift
in lowest position.
Figure 24. Pneumatic motor lift
fully raised.
Figure 25. Line sets placed in bottom cutout.
Line set
placed in
outer support
container
cutout
Note:
Verify that all line clamps are closed and
located as close as possible to the body of the BPC.
18. Attach the hanging tabs on the bottom of the BPC
to the pins at the bottom back of the outer support
container (Figure 26).
Note:
Do not attach the bottom
front BPC tabs.