Thermo Scientific 3960, Руководство по эксплуатации и техническому обслуживанию

Страница: 10 / 54

29 cu ft Environmental Chamber 1-3 Thermo Scientific
Section 1
Installation and Start-Up
Install the Unit
The Model 3960 Series Reach-In Incubator has four basic modes that
allow incubator setup: Run, Setpoints, Calibration and System
Configuration.
• Run is the default mode during normal operation.
• Set is used to enter system setpoints.
• Calibration is used to calibrate various system parameters.
• Configuration allows for custom setup of various options.
The chart below shows the selections under each of the modes.
Scroll for Parameters Arrows : Steps the operator through the parameters
of SET, CAL and CONFIG Modes. The right arrow goes to the next
parameter, the left arrow returns to the previous parameter.
Up Arrow : Increases or toggles the parameter values that have been select-
ed in the SET, CAL, and CONFIG Modes.
Enter : Must press Enter key to save to memory all changed values.
Down Arrow : Decreases or toggles the parameter values that have been
selected in the SET, CAL and CONFIG Modes.
Silence Key : Press to silence the audible alarm. See Section 4 for alarm
ringback times.
Units must be installed against a wall or similar structure. Maintain a three
inch clearance behind the incubator for electrical connections.
Locate the unit on a firm level surface capable of supporting the unit’s
weight of approximately 500 lbs. Position it away from doors and windows
and heating and air conditioning ducts.
Warning This incubator weighs approximately 500 lbs. Have sufficient
personnel available when moving.
s
Keypad Operation
RUN SETPOINT CALIBRATION CONFIGURATION
Default Mode Temperature Temp Offset Audible
Overtemp Access Code
Temp Lo Alarm
Temp Relay
RS485 Address