Thermal Dynamics CUTMASTER 39, Руководство по обслуживанию

Страница: 7 / 80

cutmaster 39
Manual 0-4976 1-1 GENERAL INFORMATION
SECTION 1:
GENERAL INFORMATION
1.01 Notes, Cautions and Warnings
Throughout this manual, notes, cautions, and
warnings are used to highlight important informa-
tion. These highlights are categorized as follows:
NOTE
An operation, procedure, or background infor-
mation which requires additional emphasis or is
helpful in efficient operation of the system.
CAUTION
A procedure which, if not properly followed, may
cause damage to the equipment.
!
WARNING
A procedure which, if not properly followed,
may cause injury to the operator or others in
the operating area.
1.02 Important Safety Precautions
!
WARNING
OPERATION AND MAINTENANCE OF
PLASMA ARC EQUIPMENT CAN BE DAN-
GEROUS AND HAZARDOUS TO YOUR
HEALTH.
Plasma arc cutting produces intense electric and
magnetic emissions that may interfere with the
proper function of cardiac pacemakers, hearing
aids, or other electronic health equipment. Persons
who work near plasma arc cutting applications
should consult their medical health professional
and the manufacturer of the health equipment to
determine whether a hazard exists.
To prevent possible injury, read, understand
and follow all warnings, safety precautions
and instructions before using the equipment.
Call 1-603-298-5711 or your local distributor
if you have any questions.
GASES AND FUMES
Gases and fumes produced during the plasma cut-
ting process can be dangerous and hazardous to
your health.
• Keep all fumes and gases from the breath-
ing area. Keep your head out of the welding
fume plume.
• Use an air-supplied respirator if ventilation is
not adequate to remove all fumes and gases.
• The kinds of fumes and gases from the plas-
ma arc depend on the kind of metal being
used, coatings on the metal, and the different
processes. You must be very careful when
cutting or welding any metals which may
contain one or more of the following:
Antimony Chromium Mercury
Arsenic Cobalt Nickel
Barium Copper Selenium
Beryllium Lead Silver
Cadmium Manganese Vanadium
• Always read the Material Safety Data Sheets
(MSDS) that should be supplied with the
material you are using. These MSDSs will
give you the information regarding the kind
and amount of fumes and gases that may be
dangerous to your health.
• For information on how to test for fumes and
gases in your workplace, refer to item 1 in
Subsection 1.03, Publications in this manual.
• Use special equipment, such as water or
down draft cutting tables, to capture fumes
and gases.
• Do not use the plasma torch in an area where
combustible or explosive gases or materials
are located.
• Phosgene, a toxic gas, is generated from the
vapors of chlorinated solvents and cleansers.
Remove all sources of these vapors.
• This product, when used for welding or cut-
ting, produces fumes or gases which contain
chemicals known to the State of California to
cause birth defects and, in some cases, can-
cer. (California Health & Safety Code Sec.
25249.5 et seq.)