Thermal Dynamics CUTMASTER 39, Руководство по обслуживанию

Страница: 15 / 80

cutmaster 39
Manual 0-4976 2-1 INSTALLATION
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
This Operating Manual applies to just
specification or part numbers listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words
WARNING,
CAUTION
, and
NOTE
may appear. Pay
particular attention to the information provided
under these headings. These special annotations
are easily recognized as
follows:
!
WARNING
A WARNING gives information regarding
possible personal injury.
CAUTION
A CAUTION refers to possible equipment dam-
age.
NOTE
A NOTE offers helpful information concerning
certain operating procedures.
Additional copies of this manual may be
purchased by contacting Thermal Dynamics at
the address and phone number in your area listed
in the inside back cover of this manual. Include
the Operating Manual number and equipment
identification numbers.
Electronic copies of this manual can also be
downloaded at no charge in Acrobat PDF format
by going to the Thermal Dynamics web site listed
below and clicking on Thermal Dynamics and
then on the Literature link:
http://www.thermal-dynamics.com
2.02 Equipment Identification
The unit’s identification number (specification or
part number), model, and serial number usually
appear on a data tag attached to the rear panel.
Equipment which does not have a data tag such
as torch and cable assemblies are identified
only by the specification or part number
printed on loosely attached card or the shipping
container. Record these numbers on the bottom of
page 1 for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against
the invoice to make sure it is complete and in-
spect the equipment for possible damage due to
shipping. If there is any damage, notify the car-
rier immediately to file a claim. Furnish complete
information concerning damage claims or ship-
ping errors to the location in your area listed in
the inside back cover of this manual.
Include all equipment identification numbers as
described above along with a full description of
the parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging
the equipment when using bars, hammers, etc., to
un-crate the unit.