Thermal Arc PRO-WAVE 300 TSW, Руководство по обслуживанию

Страница: 39 / 110

PRO-WAVE 300TSW
August 10, 2005
4-9
4.06 SET-UP FOR SMAW (STICK) AND
GTAW (TIG)
Conventional operating procedures apply when using the
Welding Power Source, i.e. connect work lead directly to
work piece and electrode lead is used to hold electrode.
Wide safety margins provided by the coil design ensure
that the Welding Power Source will withstand short-term
overload without adverse effects. The welding current
range values should be used as a guide only. Current
delivered to the arc is dependent on the welding arc
voltage, and as welding arc voltage varies between
different classes of electrodes, welding current at any one
setting would vary according to the type of electrode in
use. The operator should use the welding current range
values as a guide, then finally adjust the current setting
to suit the application.
WARNING
Before connecting the work clamp to the work
and inserting the electrode in the electrode
holder make sure the Primary power supply
is switched off.
CAUTION
Remove any packaging material prior to use.
Do not block the air vents at the front or rear
or sides of the Welding Power Source.
CAUTION
DO NOT change the Weld Mode or Weld
Process Mode until after POST-FLOW time has
finished.
Art # A-05530
Figure 4-4: 300TSW AC/DC Set-up