Thermal Arc Fabricator 140, Руководство по обслуживанию, Страница: 34 / 84

FABRICATOR 140, 180 INSTALLATION
Manual 0-4992 3-10 Janua r y 25, 2008
Route the Wire Through the Feedhead
1. Loosen P r essu r e Adjust Device (Fig. 3-10).
2. Open P r essu r e Adjust Device (Fig. 3-10).
3. Open P r essu r e A r m (Fig. 3-10).
4. Place the end of the wi r e into the Inlet Wi r e Guide,
feeding it ove r the Feed r oll. Make ce r tain that the
p r ope r g r oove is being used (Fig. 3-11).
5. Pass the wi r e into the Gun Line r of the Gun Cable End
(Fig. 3-11).
6. Close the P r essu r e A r m (Fig. 3-11).
7. Close the P r essu r e Adjust Device. Tighten it to a “snug”
condition (Fig. 3-11).
8. Figu r e 3-12 shows the r esult with the wi r e installed.
Art # A-07912
Pre ssu re Adj us t Device
Pre ssu re Arm
Figu r e 3-10: Opening P r essu r e A r m
Art # A-07913
Pre ssu re Adj us t Device
Pre ssu re Arm
S pool Wire G u ide
Wire
Feedroll
G un Cable E n d
Figu r e 3-11: Inse r ting Wi r e
Art # A-07915
Figu r e 3-12: Wi r e Installed