Owner’s Manual
11
Step 6: Attaching Pedal Tube Assembly
Attach the Right Pedal (No.26)
and Left Pedal (No.27) to their
respective Pedal Tube (No.93
and No.19) using:
4-Pedal Screws (No.20)
4-Flat Washers (No.14)
Insert Pedal Screw (No.20)
and Flat Washers through the
holes and tighten with
Wrench.
Step 7: Attaching Pedals
Fig. 6
15
94 3
19 97
24
55
94
3
97
93 15
Fig. 7
27 14
19
20
93
26
20
14
Attach Left Pedal Tube (No.19)
to Roller (No.97). Align the
Left Pedal Tube (No.19) with
the Left Connecting Tube
(No.24). Insert the Hex Head
Bolt (No.15)M10*55 through
the Left Pedal Tube (No.19)
and Left Connecting Tube
(No.24). Put the Flat Washer
(No.94) on and secure the Hex
Head Bolt (No.15) with the
Lock Nut (No.3) until tight.
Attach Right Pedal Tube
(No.93) to Roller (No.97).
Align the Right Pedal Tube
(No.93) with the Right
Connecting Tube (No.55).
Insert the Hex Head Bolt
(No.15)M10*55 through the Right Pedal Tube (No.93) and Right Connecting Tube (No.55). Put the Flat
Washer (No.94) on and secure the Hex Head Bolt (No.15) with the Lock Nut (No.3) until tight.
Owner’s Manual
14
• Hold a detailed inspection of the equipment every 3 months. Pay special attention to components
which are the most susceptible to wear and tear, i.e. hinge bolt with roller, crank, connecting
points and wheels. Tighten loose bolts as needed. Any defective components should be replaced
immediately to maintain the safety level of this equipment.
• Make sure all bolts and nuts are tight prior to each workout
• After using the machine for a period of time, there might be some noise coming from the Sliding
Block (No.49) located below the Left and Right Pedals, see drawing below. You can add grease to
lubricate and minimize the noise.
• Roller (No.97) needs to be lubricated from time to time, also refer to the illustration below.
• Roller Hole also needs to be lubricated as below.
MAINTENANCE
