7. Once Left Hex Nut and Left Lock Nut are securely tightened, one to two threads of Left Hinge Bolt
should be exposed.
Owner’s Manual
7
Locate the Right Hinge Bolt.
Please note that the Right Hinge
Bolt is marked with the “R”,
as illustrated.
IMPORTANT NOTE:
The Right
Hinge Bolt has a left-hand thread,
so you need to screw the Hex Nut
and Lock Nut onto the Right Hinge
Bolt in a counterclockwise
direction.
Fig. 2b
Step 2b: Attaching Right Hinge Bolt
1. Bring Right Crank (No.83) to high position, and insert Right Hinge Bolt (No.42) with Roller (No.97)
through Crank.
2. Place Spring Washer (No.6) over Right Hinge Bolt.
3. Screw Right Hex Nut (No.100) by hand onto Right Hinge Bolt in a counterclockwise direction.
4. Tighten Right Hex Nut by screwing it in counterclockwise direction with Single Wrench provided
until tight against Spring Washer and Crank.
Owner’s Manual
18
EXERCISE COMPUTER
SPECIFICATIONS:
TIME (TM)........................00:00-99:59
SPEED (SPD)...................0.0-99.9KPH or MPH
DISTANCE (DIST)...........0.00-999.9KM
CALORIES (CAL).............0-999KCAL
COUNTS (CNTS)
KEY FUNCTION:
MODE:
1) Press the key to select TIME, CALORIE, SPEED & DISTANCE to be displayed in
‘ELLIPTICAL” MODE.
2) Press the key to select TIME, CALORIE & COUNT to be displayed in “STEPPER” mode
SELECT:
Press and hold the key for more than 3 seconds to change exercise mode between “ELLIPTICAL” .
& “STEPPER”
OPERATION PROCEDURES:
1. AUTO ON/OFF:
The system turns on when any key is pressed or when it receives an input from the speed sensor.
The processor turns off automatically when the speed sensor has no signal input or no key is pressed
for approximately 4 minutes. The TIME, CALORIE, SPEED & DISTANCE values will be on hold and
then accumulate again when the workout is resumed.
2. AUTO SCAN:
Automatic display of the following functions in the order shown, with each value held for
4 seconds:
TIME-CALORIE-SPEED-DISTANCE in ELLIPTICAL mode
TIME-CALORIE-COUNT in STEPPER mode
