Owner’s Manual
12
Insert the Right Handlebar (No.22) into Right
Connecting Tube (No.55) and Left Handlebar (No.40)
into Left Connecting Tube (No.24). Select a height
setting that is comfortable to the user and make sure
both Handlebars are set at the same height. Lock each
Handlebar in place with Locking Knob (No.34) and
Plastic Knob Nut (No.95).
Step 8: Attaching Handles
Fig. 8
95
55
95
22
34
36
40
34
24
Regularly check all bolts and other connections and ensure that the machine is in safe condition
before using the Orbitrek™ X2™ machine.
Hold a detailed inspection of the equipment every 3 months. Pay special attention to components
which are the most susceptible to wear and tear, i.e. hinge bolt with roller, crank, connecting
points and wheels. Tighten loose bolts as needed. Any defective components should be replaced
immediately to maintain the safety level of this equipment.
Owner’s Manual
13
Connect sensor wire, then install the Computer (No.37) into
the Support Tube of Main Frame (No.36). Insert guides on
the bottom of the Computer into opening on the Main
Frame and pull forward until locked in end position.
For detailed instruction of changing computer display for
different excersize modes, please refer to “EXERCISE
COMPUTER” section in this instruction manual.
Please refer to “Changing Exercise Mode Chart” for Elliptical Mode setup.
Step 9: Connecting Sensor and Computer
Battery assembly:
Open the upper cover
of the Computer, then
install the battery into
the battery compartment.
BATTERY
To remove the Computer,
pull the top, slide the
Computer downwards and
then pull from tube bracket.
Insert the
Computer
into the tube
bracket.
36
37
Fig. 9
