IOM CRUZcontrol® Generation2 for NBC
P/N: 1118211
Revision Date: 05/31/2019
Page
54
of
66
Example 8: Product Gapping
The following describes a technique, using CRUZcontrol, which creates a gap in a train of moving
product. In the situation described, the gap is used to allow for the raising of a product stop. This
would apply primarily to the progressive mode of accumulation control, which accumulates and
discharges from accumulation with only very minimal gaps between products.
The following illustrates an NBC-C accumulation lane used to release product to a merge conveyor. A
Product Stop is located at the end of the accumulation lane, controlled by the solenoid valve as shown.
The last two accumulation zones are also provided with brakes, as shown. These brakes are controlled
by the CRUZcontrol Logic Assemblies that also control the zone drive. Also shown just prior to the
Product Stop is a Product Present Photosensor.
