Teyme EOLO-GTE10, Инструкция по эксплуатации

Страница: 34 / 52

34
6. Working
6.2. Emptying Valve
The valve for a safe emptying can be found below the step of access to the tank’s lid. To have access
to it you will have to fold out the step.
To empty the tank, the handle of the ball valve will have to be turned in paralled position to the exit of flow.
To fill in anew the tank, close the valve.
CAUTION! When opening the valve be careful that the liquid does not spill your
hands or your feet.
6.3. Introduction of phyto-sanitary product.
There are different systems to introduce the product in the tank. The next steps must be followed:
a) The tank must be filled in at 1/3 of its capacity with clean water before including the
chemical product.
b) Activate the pump, automatically the stirring system will start. Check visually from the access
mount to the tank that the system works correctly.
c) If your machine has no chemical inductor available, empty directly the liquid products inside
the tank.
d) If your machine has no powder mixer available, et is convenable to dissolve previously the solid
products in a can exclusively for this usage before introducing it to the tank.
DANGER!
Follow always the instructions which appear in the label of the product.
6.3.1. Chemical Inductor/ Mixer
1) Open the lid of the tank and include the product in liquid or powder with all the circuit valves
closed.
2) Close the lid and open the mixing valve (A) caring that the mixer tank is not full.
3) Open the discharge-can-rinsing valve (B) and the draining valve (C) located in the lower part of
the tank.
4) Valves will be opening and closing until the mixer
tank remains empty and without traces of product.
5) The can will be cleaned introducing this one upside
down and getting the opening of the can inside the
T-shaped system of can rinsing inside the mixer
tank and pushing the legs of the T with the can, with
valves (B) and (C) open.
6.3.2. Powder mixer
1) Introduce the powder directly in the basket with grid located in one of the lids of the main tank.
2) Open the valve of the powder mixer located in one of the pump’s exits or in the distributor.
3) Once all the powder is dissolved, close the valve.