Teyme EOLO-GTE10, Инструкция по эксплуатации

Страница: 24 / 52

24
4. Description
4.4.1. Hitching Tow Bars
4.4.1.1. Eye Tow Bar
It consists of a large steel tube which is inserted into the
frame of the mistblower and it includes a homologated eye
mouth which is directly fastened to the tow bar of the tractor.
The tube can be long or short depending on the use that
wants to be given.
Both tubes include an anchoring system of chains for safety
purposes in the event of the breakage of the hitching. The long-
tube tow bar includes additionally a holder for the PTO and a
fastening to place the jackwheel whether in working mode or in
standby mode.
It is needed to assemble a homocinetic PTO shaft on the tractor’s side.
DANGER! Stop always the PTO when making very closed turns even if you have a
homocinetic PTO shaft available. If you do not do like this, the turns of reduced radius
made with the PTO spinning may provoke the breakage of the PTO or of the pump’s
shaft and produce big vibrations on the gear box, to the extent of causing the fan’s or
the air unit’s breaking.
4.4.1.2. Y-shaped Ball-and-Socket Turning Tow Bar
It consists of a long and large steel tube which is inserted into
the frame of the mistbloer and includes a turning ball-and-socket
bar which is fastened to both arms of the hydraulic of the tractor.
It is the model of hitching bar which enables turnings with the
most reduced angle.
It is needed to assemble a homocinetic shaft in the side of the
mistblower.
4.4.2. Axles
It exists a big variety of axles depending on the capacity of the machine and the distance from wheel
to wheel that is going to be set. All of them are fastened to the frame by means of screws. They are
straight axles without shock-absorbing system.
4.4.3. Park chocks
They are built in galvanized sheet metal. Depending on the machine they can be found under the
access footstep to the mouth of the main tank or in the mudscraper. They must be carried always in
their support for a quick manipulation whenever the machine must be parked in a little sloped area.
4.4.4. Lights Kit
It comes assembled in a turning support in the bumper of the machine where we can turn it so that it
does not disturb when working. The connection to the tractor is done by a ISO-1724 7 poles plug.
The lights kit includes a complete set of retroreflectors (front, side and rear ones).
ATTENTION! Lights are compulsory if the machine moves by public roads, whether
urban or interurban. In case of breakage of some compenents, these must be
immediately replaced. To get the device working, plug the pin to the base of the
tractor adapted for this purpose.