Teyme EOLO-GTE10, Инструкция по эксплуатации

Страница: 27 / 52

27
5. Adjustments and How to Start-up
5.3.1. Configurations
The model of PTO shaft to use depends directly on the sort of used hitching and the distance to the
machine and to the tractor.
Homocinetic Knot Constant Angle Provisory Angle
Tractor Machine Tractor Machine Tractor Machine
Eye long Hitching
Yes No 25º 25º 65º 40º
Ball and socket
turning hitching
No Yes 25º 25º 40º 65º
5.3.2. PTO Shaft Coupling
The initial assembly of the PTO shaft could imply having to cut the shaft to adapt it to the tractor to
which this one is going to be hitched. To carry out the first hitching the next steps must be followed:
1. Stop the engine and take out the contact key.
2. Hitch the mistblower to the tractor keeping the lesser distance as possible between the PTO
and the pump and following the instructions concerning the adjustment of drawbar.
3. If the PTO shaft must be cut, disassemble the two parts of the shaft. Introduce both sides of
the shaft one to the tractor and the other to the shaft of the mistblower’s pump and measure
the length that must be cut. Mark the protection shields.
4. Measure the distance between the PTO and the pump. From this measure mark again the
shield, cutting this one according to the next board:
600 40 *
800 60 *
1000 80 *
1200 100 **
1400 140 **
* increase 10 mm when the machine has a homocinetic knot
** increase 20 mm when the machine has a homocinetic know