Textron Bell 206L3, Руководство по обслуживанию

Страница: 34 / 230

BHT-206L3-MM-1
5-00-00
Page 4
Rev. 16 25 FEB 2011 ECCN EAR99
inspections are done when they are required to be
done.
3. Make sure the scheduled inspections, the special
inspections, and the required inspections for all of the
installed kits are complied with.
4. Make sure all parts and components for which
Historical Service Records are required have
documented traceability to their original installation in
the helicopter.
5. Make sure all limited life parts that have
completed their published operating limits are
replaced.
6. Make sure all of the components that have
completed their published overhaul periods are
overhauled.
7. Make sure all of the maintenance that is done on
the helicopter is done by an approved maintenance
organization.
The maintenance organization/person doing the
maintenance is responsible for the quality of the
maintenance done.
The owner/operator may choose to ask the
maintenance organization/person doing the
maintenance to perform the tasks listed by prior
arrangement through a separate formal agreement.
5-3. CRASH DAMAGE
Because of the many possible combinations that can
result from crash damage, it is not possible to include
the specific repair tasks in this category. The
helicopter mechanic must make an analysis of the
crash damage for each situation. Do the repair in
accordance with the degree of damage to the specific
part and the applicable repair procedures in this
manual. Call Bell Helicopter Textron Product Support
Engineering with your analysis of the crash damage.
5-4. TYPES OF INSPECTIONS
1. The maintenance procedures may include
scheduled inspections, special inspections, conditional
inspections, component interim inspections, and
component overhaul inspections.
a. Scheduled inspections must occur at specified
operating intervals. The intervals may be in operating
time (hours), cycles, torque events (RIN), calendar
(days, months, years) or other assigned units. This
makes sure that the helicopter is airworthy.
b. Special inspections are of a temporary nature
or of a special interval that is not consistent with the
scheduled inspections.
c. Conditional inspections do not occur at a
specified time. A conditional inspection is the result of
a known or suspected unusual event, known or
suspected malfunctions, or defects.
d. An interim inspection occurs between
overhauls.
e. The component overhaul schedule gives the
elapsed operating time at which a component must be
removed, disassembled, examined for condition, and
overhauled, in accordance with data approved by Bell
Helicopter Textron.
2. Lubrication and servicing requirements are in
addition to those stated in this chapter (Chapter 12).
3. For corrosion control, refer to the Corrosion
Control Guide, CSSD-PSE-87-001 and the
BHT-ALL-SPM.
4. For the 250-C30 series engine, refer to the
Rolls-Royce Operations and Maintenance Manual
(14W2) for the scheduled inspection, special
inspection, conditional inspection, and component
overhaul schedule.
5. For the common Bell Helicopter Textron approved
optional equipment that is integrated into this
Maintenance Manual, refer to this chapter for the
scheduled inspection, conditional inspection,
component interim inspection, and component
overhaul inspection.
6. For all other Bell Helicopter Textron approved
equipment, refer to the applicable information in this
Maintenance Manual or the specific Service
Instruction (SI) for the scheduled inspection, special
inspection, conditional inspection, component interim
inspection, and component overhaul inspection.
7. For the inspection requirements for optional
equipment approved under Supplement Type