Texas Instruments MSP50C6xx, Руководство пользователя

Страница: 84 / 390

Hardware Initialization States
3-20
3.5 Hardware Initialization States
The RESET pin is configured at all times as an external interrupt. It provides
for a hardware initialization of the MSP50C6xx. When the RESET pin is held
low, the device assumes a deep sleep state and various control registers are
initialized. After the RESET pin is taken high, the Program Counter is loaded
with the value stored in the RESET Interrupt Vector.
Note: Internal Power Reset Function
There is no power-on reset function internal to the MSP50C6xx. After the ini-
tial power-up or after an interruption in power, the RESET pin must be cycled
low-to-high. The application circuitry must therefore provide a mechanism
for accomplishing this during a power-up transition or after a power fluctua-
tion.
The application circuits shown in Section 6.1, Application Circuits, illustrate
one implementation of a reset-on-power-up circuit. The circuit consists of an
RC network (100 k
Ω
, 1
µ
F). When powering V
DD
from 0 V, the circuit provides
some delay on the RESET pin’s low-to-high transition. This delay helps to en-
sure that the MSP50C6xx initialization occurs after the power supply has had
time to stabilize between V
DD
MIN and V
DD
MAX. V
DD
MIN and V
DD
MAX are
the minimum and maximum supply voltages as rated for the device. The circuit
shown, however, may not shield the RESET pin from every kind of rapid fluc-
tuation in the power supply. At any time that the power supply falls below V
DD
MIN, even momentarily, then the RESET pin must be held low and then high
once again, either by the user of the device or by some other external circuitry
(refer to the MSP50C6xx data sheet (SPSS023), Electrical Specifications sec-
tion).
When the RESET pin is held low, the MSP50C6xx is considered reset and has
the following internal states:
RESET low . . .
-
I/O ports are be placed in a high impedance Input condition: Ports A, B,
C, D, and E.
-
All outputs on Port G is are set to low (0x0000).
-
Device is placed in a deep sleep state.
-
PLL circuitry, master clock, CPU clock, and TIMERs are stopped.
-
Current draw from the V
DD
is less than 10
µ
A in this condition.
-
Interrupt flag register (IFR at address 0x39) is not automatically cleared.
-
Internal RAM is not automatically cleared.