Texas Instruments CI2EVM BoC, Быстрый старт, Страница: 11 / 37

EVM Dual BoC
BoC - Quick Start Guide Revision 0.4 – preliminary
Page
6 of 31
II. Hardware Configuration
I. Initial Installation Procedure
The following instructions define the basic minimum installation requirements for your
BoC (Break out Card).
II. Default Jumper and Pin Settings
The following table defines the factory default configuration settings your BoC has been
shipped with.
Table 1: Factory Configuration
Reference Item Description Factory Setting
J1 2 1X4 Header N/A
J2 13 1X4 Header N/A
J3 23 Switch 0x111
J4 5 Switch 0x011
J5 6 Switch 0x111110
J6 20 1X3 Header Shunt Installed [1-2]
JP1 8 1X2 Header Shunt Installed
JP2 14 1X2 Header Shunt Installed
JP3 25 1X2 Header Shunt Installed
JP4 9 1X2 Header N/A
JP5 11 1X2 Header N/A
JP6 10 1X1 Header N/A
JP7 24 1X1 Header N/A
JP8 22 1X1 Header N/A
JP9 12 1X1 Header N/A
JP10 19 1X2 Header Shunt Installed
III. BoC Logic Power Source Selection [20]
The BoC on board logic is capable of sourcing power from either of the EVM’s (provided
the EVM’s are independently powered. Header J6 allows the user to select the 12V input
power to the BoC on board logic. The following figure illustrates the possible
configurations.
1
2
3
[1-2] Board A Supplies Power
[2-3] Board B Supplies Power
J6
Figure 4 - BoC Logic Power Source Selection