Tetra Pak HOYER COMET C, Руководство пользователя

Страница: 26 / 150

CC901AE
5-9
Tetra Pak
Hoyer
Fig. 5.3a
Fig. 5.3b
2
1
3
2
1
5.3 Mechanical and pneumatic adjustments
5.3.1 Container feed station adjustment
5.3.1a Cone feed station adjustment
Press the emergency button to turn off the
compressed air supply on the control panel.
With the cone stop blades open, insert two cones
in the magazine (Part.1, Fig. 5.3a).
Check that the cone in the released position rests
correctly in the calliper holes of the oscillating
levers (Part.2, Fig. 5.3a), then check that the
cone in the released position is 5 mm below the
cone stop blade.
Make sure that the oscillating cone release levers
hold the cornets without exerting too much
pressure.
5.3.1b Cup feed station adjustment
Use the jog command (Fig. 5.1), to position
the suction cups at their maximum height.
Then place an ice cream cup in the magazine and
check that the blades (Part. 1, Fig. 5.3b) hold
the cup without squashing it. Adjust the height
of the cup feed by turning the knob (Part. 2, Fig.
5.3b) so that the suction cups touch the bottom
of the container.
If the distance is too great , lower the moveable
part of the cone stop blade support and
magazines; if the released cone is between the
cone stop blades, raise the cone magazines to
the required distance.
After performing this adjustment, check that the
plate that pushes the cones grazes the edge of
the cornet; if it does not, adjust the position of
the plate (Part.3, Fig. 5.3a).
At this point check that at low speed the cone is
released immediately after the lamella chain has
stopped.
Follow the above procedure when changing
format.
F
NOTE:
If the machine is set up to produce different types
of cups, it is advisable to make a note of the
different adjustments in order to make format
changes easier and quicker.