TESVOLT TS HV70 Outdoor, Инструкция по установке и эксплуатации

Страница: 24 / 60

24 InstallatIon
© TESVOLT We reserve the right to make technical changes! RD.TI.026.E.ENG_Installation_Manual_TSHV70OD_v.B.01 Last revised 01/2021
6 INSTALLATION
6.1 SETTING UP THE BATTERY CABINET
1
Transport the battery cabinet to the final installation site. It is essential that you observe the notes and
specifications in section “3.5 Installation site” on page 11. Remove the transport packaging and
accessory pack. Check the battery cabinet and the other materials for transport damage and com-
pleteness.
2
The battery cabinet’s base cladding must be removed before
installing the battery cabinet
A on the concrete base R or a
suitable foundation. Dismantle the two safety screws on the rear
of the battery cabinet at the corners of the base using the special
hex key
N
and remove the rear base cover.
3 Dismantle the three screws on the front of the battery cabinet on
the upper side of the base strip using a TX25 Torx screwdriver
and remove the front base cover.
4
When using an optional concrete base R , this must first be
installed in a suitable foundation pit in accordance with the instal-
lation instructions supplied. Before installing the battery cabinet
on the base, the perpendicularity of the base must be thoroughly
checked and corrected if necessary. Deviations can cause prob-
lems with the subsequent installation.
Finally, refill the foundation pit.
WARNING! Risk of damage to the battery cabinet
When transporting by crane, the battery cabinet must be fastened to all four ring screws such that the
cable angle is 60° to 90°. Any variation from this requirement can lead to the battery cabinet being
damaged.
CAUTION! Risk of injury due to improper transport
Incorrect transport can lead to accidents that may result in severe injuries. The following must there-
fore be taken into consideration when transporting the battery cabinet with a crane:
• The safety instructions in section “3.4 Transport at the end customer‘s site” on page 10.
• The necessary prerequisites such as qualifications and certificates for operating a crane including
instruction in its operation.
•
The relevant standards and regulations for working with suspended loads.
STOP