TESTO 6383, Инструкция по эксплуатации

Страница: 71 / 88

5 Parameterizing, adjusting and analyzing software (P2A software)
71
✓
Transmitter must be connected.
1. Click on File > New connection in the menu bar.
- Connection to the transmitter is established.
5.3.3. Analyzing/testing the transmitter
In this section, you can test the outputs of the connected
instrument, read off the limit values and reset the parameters to the
factory settings.
The function is only available for instrument files.
5.3.3.1. Analyzing/testing the instrument
✓
The required instrument file is marked.
1. Click on [Test/analyze transmitter] .
- The Properties of <Instrument type> <Serial number>
dialogue is opened with the Test/analyze transmitter register.
2. Perform action:
Action Explanation
Carrying out factory
reset Reset the unit, limit value and hysteresis
parameters to factory settings (see below).
Testing analog
output Test channel 1 (see Testing functionality of
analog outputs, page 45).
Test switch outputs Manually switch relays 1 to 4 to test for
proper function (see Testing functionality of
relay outputs, page 46).
Display min./max.
values Overview of the minimum and maximum
values measured since the last reset of the
transmitter (see Displaying min./max. values,
page 74).
3. Click on [OK] or [Cancel] to close the dialogue.
5.3.3.2. Carrying out factory reset
✓
The required instrument file is marked.
1. Click on [Test/analyze transmitter] .
- The Properties of <Instrument type> <Serial number>
dialogue is opened with the Test/analyze transmitter register.
2. Mark transmitter test.
- Current operating hours are shown.
3.
Confirm control query to perform the reset.