TESTO 6383, Инструкция по эксплуатации

Страница: 41 / 88

4 Transmitter
41
4.4.5. The individual main menus
4.4.5.1. Editing main menu of channel 1
An overview is given in Overview of the testo 6383 user menu,
page 39).
You can perform basic settings for channel 1.
1.
In the Measuring Mode press SET , select Main Menu
Channel 1 with

or

and confirm selection with SET .
One of the following parameters can now be selected using 
or  , after which the selection must be confirmed with SET :
• Channel 1 Unit
The parameter for this channel is selected.
Edit/select parameter with

or

, confirm with SET or abort
entry with ESC .
• Scale minimum for channel 1:
The lower scale limit is edited; Unit as selected above.
Editing the value: Scroll one digit to the right using

and
increase value of digit by 1 using  . Confirm with SET or abort
entry with ESC .
• Scale maximum for channel 1
The upper scale limit is edited;
Unit as selected above.
Editing the value: Scroll one digit to the right using
 and
increase value of digit by 1 using

. Confirm with SET or abort
entry with ESC .
• Signal delay ("Attenuation") for channel 1
The analog signal can be delayed ("Attenuation"); a time
constant is selected for this (1 = no delay; 2-15 = delay in
seconds)
Edit/select parameter with

or

, confirm with SET or abort
entry with ESC .
2. Continue to the main menu with  or  or return to Measuring
Mode with ESC .
4.4.5.2. Editing Main Menu Alarm
With the alarm, the relays, available as options, are programmed.
In addition, the alarm statuses are shown on the display (top right)
(even without relays).
You can choose whether the alarm is to be used to monitor limit
values or as a collective alarm. If an alarm is to be used to monitor