TESTO 6321, Инструкция по эксплуатации

Страница: 29 / 40

5 Parameterizing, adjusting and analyzing software (P2A software)
29
5.3.3.1. Analyzing/testing the instrument
✓
The required instrument file is marked.
1. Click on [Test/analyze transmitter] .
- The Properties of <Instrument type> <Serial number>
dialogue is opened with the Test/analyze transmitter register.
2. Perform action:
Action Explanation
Carry out factory
reset Reset the unit, limit value and hysteresis
parameters to factory settings (see below).
Test analog output Test channel 1 (see Testing analog output
page 29).
Display min./max.
values Overview of the minimum and maximum
values measured since the last reset of the
transmitter (see Displaying min./max. values
page 31).
3. Click on [OK] or [Cancel] to close the dialogue.
Pos: 54 /TD/Produkt verwenden/MUF 63xx/P2A/Werksreset durchführen @ 3\mod_1237379864072_79.doc @ 29887 @ 4
5.3.3.2. Carrying out factory reset
✓
The required instrument file is marked.
1. Click on [Test/analyze transmitter] .
- The Properties of <Instrument type> <Serial number>
dialogue is opened with the Test/analyze transmitter register.
2. Mark transmitter test.
- Current operating hours are shown.
3.
Confirm control query to perform the reset.
- The values are reset to the customer-specific factory settings.
4.
Click on [OK] or [Cancel] to close the dialogue.
Pos: 55 /TD/Produkt verwenden/MUF 63xx/P2A/Analogausgang testen 6321 @ 4\mod_1244461179628_79.doc @ 44787 @ 4
5.3.3.3. Testing analog output
✓
The required instrument file is marked.
1. Click on [Test/analyze transmitter] .
- The Properties of <Instrument type> <Serial number>
dialogue is opened with the Test/analyze transmitter register.
2. Mark channel and test values.