4 Transmitter
15
CAUTION
Damage to electronic components!
> The terminal strip can be removed from the circuit board in
order to screw on the cable ends. After wiring, be sure to
completely attach the terminal strip on the contact pins as pre-
assembled.
Only have the transmitter wired and connected by
authorized personnel with the voltage disconnected.
1.
Loosen and remove housing screws (
1
).
2.
Remove upper part of housing (
2
) from lower part of housing (
3
)
and place on a clean surface.
3.
Wire instrument (see 3-wire system page 16, 4-wire system
page 16).
4
Place upper part of housing (
2
) on lower part of housing (
3
) and
tighten with housing screws (
1
).
5.
On instruments with display: Remove protective film (
4
) from
the display cutout of the housing cover.
Содержание 6321
Страница 2: ...2 ...
Страница 40: ...0970 6321 en 03 ...
