Tesmec FRB616, Руководство по установке, эксплуатации и техническому обслуживанию

Страница: 21 / 102

TENSIONER
Model: FRB616
Manual: MI-FRB616-020-01-GB Date: 11.03.2015 Author: M. Colleoni Page: 18 of 33
4.14 ROPE LOCKING CLAMP (OPTIONAL)
The rope locking clamp allows blocking the rope end towards the reel
winder and therefore the operations for removing the reel are speed up.
To engage the rope locking clamp, turn the selector (table 4, pos.31-32) on
position (leftwards - blocked
– no light) and keep them in position
for a few second to allow the complete closing of the clamp.
To dis-engage the rope locking clamp, turn the selector on position
(rightwards
– free – green light) and keep them in position for a few second
to allow the complete opening of the clamp.
4.15 COMPRESSOR CONNECTION (OPTIONAL)
The machine has been studied to be connected to a Tesmec compressor.
a. Connect the rapid couplers (table 7, pos. 3 and 4).
b. Start the machine, turn the selector (table 4, pos. 33) towards right position .
c. Lower the lever (table 7, pos. 2) in "A" position.
Once ended the compressing operations, to use the machine act as follows:
a. lift the lever (table 7, pos. 1) in "B" position.
b. turn the selector (table 4, pos. 33) towards left position .
c. remove the rapid couplers (table 7, pos. 3 and 4).
ATTENTION: the connection of the rapid couplers has to be effectuated with the lever
(table 7, pos. 2) in "B" position to discharge the pressure in the hydraulic circuit.
If there is residual pressure in the hydraulic circuit, it is not possible to connect and
disconnect the rapid couplers.
ATTENTION: Use the press only when the capstans are stopped.