TESA Auto lift system, Руководство по установке и эксплуатации

Страница: 15 / 21

15
Detailed description of functions
In the following the several functions of the Autolift system are exactly described. Before using the
system plead read this manual attentively. The below described functions are
only available at
ignition off . Nevertheless it is possible to use the most functions with running motor, except the
safety functions (see chapter).
ON/OFF (taste 1)
Press ON/OFF to switch on the system, shortly after the system starts Autotest*, this
is the control sequence with flashing LED’s. At the end of the test, if all jacks are in
driving position, the LED
START lights up and shows the system can be operated now.
If not all jacks are in driving position the LED GET UP is on and shows there is only this
function available.
*if the control sequence does not start look to the panel if there are other LED’s lighted and show a
malfunction. See chapter.
START (taste 2)
Press START to operate the first step of levelling functions. The jacks ascend to
vertical position and wait for the next order. This safety function is necessary to
control visually the free running of jacks. In this position you have the possibility to
put spacers between jack and floor. At the end of phase
START the LED’s AUTO * -
MANUAL – GET UP are lighted and show the availability of these functions.
*If the LED AUTO is not lighted the automatic levelling is not possible, shown by the LED unacceptable
incline. Then you can use the manual leveling, but a correct leveling cannot be guaranteed