TESA Auto lift system, Руководство по установке и эксплуатации

Страница: 11 / 21

11
1. Press the arrow button of jack 1 until it reaches the driving position. The system answers
with a long beep.
2. Adjust with the screw (see picture below) by turning in a later point or turning out an
earlier point of switching off.
3. Move again the jack down and up to the point of switching off.
4. Repeat this procedure until the adjustment is correct. Then fix the lock nut.
5. Repeat 1-4 at all jacks in the same manner.
6. Move all jacks to driving position if not yet done.
7. Finish the calibration mode by pressing ON/OFF .
8. Switch ON/OFF again. The system starts now the self control shown by the flashing LED’s.
At last the LED START lights up. If not the LED GET UP lights up. It shows that one or more
limit switches are not closed correctly. In this case control and adjust the limit switches
again.
Important remarks for the adjustment
The limit switches must not react at the mechanical end point of the jack. There
must remain a duty cycle. To control the duty cycle bring the jack to the driving
position and press the jack with the hand upwards. The play between electrical
and mechanical end point must be about 1 cm.
If the limit switches are not adjusted correctly the most functions are blocked. Pay
attention to accurate adjustment.
SCREW
LOCK NUT