
Operator's Manual
First Edition • First Printing
Part No. 216062
37
Test the Drive Controls
4 Release the parking brake.
5 Activate the drive functions.
Result: Drive forward and reverse should
operate in the direction expected, and only at
walking speed.
6 Activate the steer functions.
Result: Steer right and left functions should
operate in the directions expected.
7 Apply the parking brake.
Test the Ground and Pendant Controls
8 Activate all functions from the ground and
pendant controls locations (scissor, tower tilt,
turntable, platform tilt, tower and platform rotate
and extend/retract functions).
Result: All functions should not operate.
9 From the ground controls, fully extend the
outriggers to the hard stop.
Result: The outriggers should extend completely
out.
Note: Be sure that both outrigger safety chains
have been removed from the outriggers before
extending the outriggers.
10 Using the outrigger jack handle lower each
outrigger until the outrigger wheel reaches the
bridge deck. Continue to turn each outrigger
jack handle until each outrigger wheel has
extended another 4 inches.
Result: The outrigger jack handle and outriggers
should operate as expected.
Note: Do not extend the outrigger wheels beyond 4
inches as this can result in the front drive wheel
losing traction.
11 Activate each scissor function from the ground
and pendent controls locations.
Result: Scissor open/close function should all
operate.
12 Activate each tower tilt, turntable, platform tilt,
tower, and platform rotate functions from the
ground and pendant controls locations.
Result: Tower tilt up/down, turntable left/right,
platform tilt up/down, tower up/down, and
platform rotate left/right functions should not
operate.
13 Fully extend the scissor stack.
14 Activate the tower tilt up/down functions from
the ground and pendant controls locations.
Result: Tower tilt up/down function should
operate.
15 Slightly tilt the tower from the stowed position.
16 Activate the turntable, platform tilt, tower and
platform rotate functions from the ground and
pendant controls locations.
Result: Turntable left/right, platform tilt up/
down, tower up/down, and platform rotate left/
right functions should not operate.
17 Tilt the tower to about 30 degrees, tripping the
tower tilt limit switch (tower tilt indicator light will
come on the remote pendant controls).
18 Activate the turntable functions from the ground
and pendant controls locations.
Result: Turntable left/right function should
operate.
19 Rotate the turntable until the turntable has
reached its hard stop (90 degrees from stowed
position).
20 Activate tower tilt functions from the ground and
pendant controls locations.
Result:Tower tilt up/down functions should
operate.
Inspections