Terex Genie S-60 DC, Руководство по обслуживанию и ремонту

Страница: 29 / 171

July 2021 Service and Repair Manual
Platform Controls
Part No. 1299608GT S ® -60 DC • S ® -60 FE 17
How to Adjust the Joystick Max-out Setting How to Adjust the Maximum
Speed Setting (Hydraulic
Functions)
There are three types of speed settings to adjust:
High Flow Functions: Primary Up/Down, Primary
Extend/Retract and Turntable rotate.
Low flow Functions
: Jib Up/Down, Platform
rotate and Platform level.
Other Functions: Steering is set by a fixed flow
regulating valve (non adjustable).
Note: Refer to Specifications,
Performance
Specifications,
for each boom function speed.
Check function pump calibration before adjusting
the maximum speed setting. Refer to Repair
Procedures,
How to Check Function Pump
Calibration .
1 Turn the key switch to platform controls.
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 Do not press down the foot switch.
4 Move and hold the drive enable toggle switch
in the right direction while holding steer in the
right direction.
5 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer joystick.
Result: The display will show FAULTS.
6 Momentarily activate steer in the right
direction until SETTINGS is shown on the
display.
7 Momentarily activate the drive enable toggle
switch in the right direction until VALVE AND
SENSOR SETTINGS is shown on the display.
8 Momentarily activate the drive enable toggle
switch in the right direction until CALIBRATE
TILT SENSOR is shown on the display.
9 Momentarily activate steer in the right
direction until VALVE MAXIMUM CURRENT
is shown on the display.
10 Momentarily activate the drive enable switch
to enter the sub menu VALVE MAXIMUM
CURRENT.
High Flow Functions:
The function speeds are fixed by the flow rate
supplied by the hydraulic pump. Excess flow is
rarely produced resulting in little or no oil going
over relief.
11 Momentarily activate and release the high
flow boom function in one direction.
Result: The display shows the name, direction
and current value in milliamps for the function
being moved. Example: “PRI_UP_MAX 590.”
12 Momentarily activate steer right five times to
increase the mA value.
13 Activate the boom function again by pressing
the foot switch and moving the function switch
(or joystick to full speed) in the same
direction. Momentarily active steer left once
every three seconds to decrease the
maximum mA value where pressure rises to
about 3000 psi / 207 bar and an audible alarm
sounds.
Note: The turntable function will only increase
300 psi and no audible alarm. When the 300 psi
occurs, proceed to the next step.