Terex Genie GS-1530, Руководство по обслуживанию и ремонту

Страница: 136 / 341

Service and Repair Manual March 2021
Scissor Components
120 GS ™ -30 • 32 • 46 • 47 Part No. 1272217GT
58 Attach a lifting strap from an overhead crane
to the number 4 outer arm at the battery side
(index #25).
59 Remove the retaining fasteners from the
number 4 center pivot pin (index #7) at the
battery side.
60 Place a rod through the number 4 center pivot
pin at the battery side (index #7) and twist to
remove the pin.
61 Remove the number 4 outer arm (index #25)
from the machine.
Crushing hazard. The number
4 outer arm (index #25) may
become unbalanced and fall if
not properly supported when
removed from the machine.
62 Attach a lifting strap from an overhead crane
to the number 4 inner arm (index #24). Raise
the arm to a vertical position.
63 Remove the retaining fasteners from the
number 4 pivot pin at the steer end of the
machine (index #8).
64 Use a soft metal drift to remove the number
4 pivot pin (index #8) from the steer end of the
machine. Remove the number 4 inner arm
(index #24) from the machine.
Crushing hazard. The number
4 inner arm (index #24) may
become unbalanced and fall if
not properly supported when
removed from the machine.
65 Remove the cables from cable bridges f,h,i,j,k
and l.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
66 Attach a lifting strap from an overhead crane
to the number 3 outer arm at the ground
control side (index #9).
67 Remove the retaining fasteners from the
number 3 center pivot pin (index #10) at the
ground control side.
68 Place a rod through the number 3 center pivot
pin at the ground control side (index #10) and
twist to remove the pin.
69 Remove the retaining fasteners from the
number 3 pivot pin (index #29) at the non-
steer end.
70 Use a soft metal drift to remove the number
3 pivot pin (index #29) from the non-steer end
of the machine. Remove the number 3 outer
arm at the ground control side (index #9) from
the machine.
Crushing hazard. The number
3 outer arm at the ground control
side (index #9) may become
unbalanced and fall if not
properly supported when
removed from the machine.
71 Attach a lifting strap from an overhead crane
to the number 3 outer arm at the battery side
(index #9).
72 Remove the number 3 outer arm (index #9)
from the machine.
Crushing hazard. The number
3 outer arm (index #9) may
become unbalanced and fall if
not properly supported when
removed from the machine.
73 Attach a lifting strap from an overhead crane
to the number 3 inner arm (index #28). Raise
the number 3 inner arm and place a 4 x 4 x
48 inch / 10 cm x 10 cm x 1.2 m block across
the link stack to gain access to the barrel end
pivot pin (index 27).