Terex Genie GS-1530, Руководство по обслуживанию и ремонту

Страница: 110 / 341

Service and Repair Manual March 2021
Scissor Components
94 GS ™ -30 • 32 • 46 • 47 Part No. 1272217GT
27 Remove the cables from the number 3 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
28 Disconnect the number 3 cable bridge from
the number 3 outer arm (index #11) and
remove the cable bridge from the machine.
29 Remove the retaining fasteners from the
number 4 pivot pin (index #1).
30 Use a soft metal drift to remove the number
4 pivot pin (index #1). Remove the platform
mount bracket from the machine.
31 Attach a lifting strap from an overhead crane
to the number 3 outer arm at the ground
control side (index #11).
32 Remove the retaining fasteners from the
number 3 center pivot pin (index #2) at the
ground control side.
33 Place a rod through the number 3 center pivot
pin at the ground control side (index #2) and
twist to remove the pin.
34 Remove the retaining fasteners from the
number 3 pivot pin (index #12) at the non-
steer end.
35 Use a soft metal drift to remove the number
3 pivot pin (index #12) from the non-steer end
of the machine. Remove the number 3 outer
arm at the ground control side (index #11)
from the machine.
Crushing hazard. The number
3 outer arm at the ground control
side (index #11) may become
unbalanced and fall if not
properly supported when
removed from the machine.
36 Attach a lifting strap from an overhead crane
to the number 3 outer arm at the battery side
(index #11).
37 Remove the retaining fasteners from the
number 3 center pivot pin (index #2) at the
battery side.
38 Place a rod through the number 3 center pivot
pin at the battery side (index #2) and twist to
remove the pin.
39 Remove the number 3 outer arm (index #11)
from the machine.
Crushing hazard. The number
3 outer arm (index #11) may
become unbalanced and fall if
not properly supported when
removed from the machine.
40 Attach a lifting strap from an overhead crane
to the lug of the rod end of the lift cylinder.
41 Remove the retaining fasteners from the lift
cylinder rod end pivot pin (index #3).
42 Use a soft metal drift to remove the lift
cylinder rod end pivot pin (index #3) from the
machine.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
43 Place a 4 x 4 x 10 inch / 10 x 10 x 25 cm
block onto the number 1 inner arm cylinder
plate (index #8).
44 Lower the cylinder onto the block.
Bodily injury hazard. Keep
hands clear of moving parts
when lowering the cylinder.
45 Attach a lifting strap from an overhead crane
to the number 3 inner arm (index #10). Raise
the arm to a vertical position.