Terex Genie GS-1530, Руководство по обслуживанию и ремонту

Страница: 52 / 341

Service and Repair Manual March 2021
Ground Controls
36 GS ™ -30 • 32 • 46 • 47 Part No. 1272217GT
12 Place the new level sensor onto the level
sensor mount bracket with the "X" on the level
sensor base closest to the long side of the
level sensor mount, and the "Y" on the level
sensor base closest to the short side of the
level sensor mount.
Tip-over hazard. Failure to install
the level sensor as instructed,
could result in the machine
tipping over, causing death or
serious injury.
Steer End
Non-steer End
1 limit switch
2 level sensor mount bracket
3 level sensor S7
4 scissor chassis
5 alarm H5
13 Install the level sensor retaining fasteners
through the level sensor and springs, and into
the mount bracket. Tighten the fasteners and
measure the distance between the level
sensor and the level sensor mount bracket.
Result: The measurement should be
approximately 0.375 inch / 10 mm.
14 Connect the chassis wire harness to the level
sensor wire harness.
15 Turn the key switch to the ground control and
pull out the red Emergency Stop button to the
on position at the ground controls.
16 Adjust the level sensor retaining fasteners
until the bubble at the top of the level sensor
is centered in the circles.
Result: The tilt sensor alarm should not
sound.
17 Raise the platform slightly.
18 Return the safety arm to the stowed position.
19 Lower the platform to the stowed position.
20 Center a lifting jack under the drive chassis at
the ground controls side of the machine.
21 Raise the machine approximately 2 inches /
5 cm. Place blocks under the chassis for
support.