Terex Genie AL5HT, Руководство по обслуживанию

Страница: 60 / 94

Service Manual May 2015
Tower Components
50 AL5HT Part No. 1265482
14 Pull the extend cable free of the pulley mount
and lay it flat on top of the number 3 tower
tube.
Bodily injury hazard. Cables
can fray. Always wear adequate
hand protection when handling
the cable.
15 Label and remove the wear pads from the
extension end of the number 2 tower tube.
16 Attach a lifting strap from an overhead crane
to the number 3 tower tube.
17 Support and slide the number 3 tower tube
from the number 2 tower tube and place it on a
structure capable of supporting it.
Crushing hazard. The number
2 and 3 tower tubes could
become unbalanced and fall
when removed from the number
1 tube if not properly supported
by the overhead crane.
Bodily injury hazard. Cables
can fray. Always wear adequate
hand protection when handling
the cable.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
Note: During removal, the overhead crane strap will
need to be carefully adjusted for proper balancing.
3-5
How to Remove the Tower Lift
Cylinder
The tower lift cylinder raises and lowers the tower
assembly. The tower lift cylinder is equipped with
counterbalance valves to prevent movement in the
event of a hydraulic line failure.
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose end must be
replaced and then torqued to specification during
installation. Refer to Section 2, Hydraulic Hose and
Fitting Torque Specifications.
1 Tag, disconnect and plug the tower lift cylinder
hydraulic hoses. Cap the fittings on the
cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
2 Support both ends of the cylinder with a
suitable device to prevent it from falling.
3 Remove the pin retaining fasteners from both
the rod end and barrel-end pivot pins.
4 Place a rod through the pins and twist to
remove. Guide the cylinder out the pivot end of
the tower and carefully remove the cylinder
from the machine.
Component damage hazard.
Cables and hoses can be
damaged if the cylinder is
dragged across them.