Terex Genie AL5HT, Руководство по обслуживанию

Страница: 57 / 94

May 2015 Service Manual
Tower Components
Part No. 1265482 AL5HT 47
3-2
How to Remove the Cable Track
The tower cable track guides the cables and hoses
running up the tower. It can be repaired link by link
without removing the cables and hoses that run
through it. Removing the entire tower cable track is
only necessary when performing major repairs that
involve removing the tower.
Component damage hazard.
The tower cable track can be
damaged if it is twisted.
a link separation point
b lower clip
1 Use a slotted screwdriver to pry down on the
lower clip.
2 Repeat step 1 for each link.
3 To remove a single link, open the lower clip
and then use a screw driver to pry the link to
the side.
3-3
How to Remove the Tower
Assembly
Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose end must be
replaced and then torqued to specification during
installation. Refer to Section 2, Hydraulic Hose and
Fitting Torque Specifications.
1 Remove the light bar. See 2-1, How to
Remove the Light Bar Assembly.
2 Remove the cable track tube retaining
fasteners at the number 3 tower tube.
3 Remove the hose and cable clamp fasteners
and clamps from the underside of the cable
track on the side of tower tube number 1.
4 Place blocks between the cable track tube and
the lower cable track. Secure the cable track
together.
5 Attach a suitable lifting device to the cable
track. Carefully remove the cable track from
the tower and rest it on top of the cabinet.
Component damage hazard.
Cables and hoses can be
damaged if they are kinked or
pinched.
6 Place a block under the tower lift cylinder for
support.