Tennant T600 EE, Руководство оператора

Страница: 35 / 41

MAINTENANCE
Tennant T600 EE (04-2018)
35
4. Rotate the rear blade to a new wiping edge and
reinstall blade (Figure 78). Make sure to align the
slots in the blade with retainer tabs.
FIG. 78
5. Squeeze the squeegee frame and blade retainer
together and re-tighten the two outside knobs
(Figure 79).
FIG. 79
MACHINE JACKING
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine and remove
key.
Use the designated locations to jack up the machine for
service (Figure 80). Empty the recovery and solution
tanks and position the machine on a level surface
before jacking. Stay clear from the solution tank filter
bowl when jacking.
FOR SAFETY: When servicing machine, jack
machine up at designated locations only. Support
machine with jack stands. Use jack or hoist that
will support the weight of the machine.
FIG. 80
PUSHING AND TRANSPORTING MACHINE
PUSHING MACHINE
If the machine becomes disabled, it can be pushed as
describe below.
Only push the machine for a very short distance and do
not exceed 3.2 kp/h (2 mph). It is not intended to be
pushed for a long distance or at a high speed.
For models equipped with an electronic parking brake
system, the brake must be disengaged before pushing
machine. To disengage brake, position the brake lever
on the transaxle to the down position (Figure 81).
FIG. 81
ATTENTION: Do not push machine for a long
distance or damage may occur to the propelling
system.
Immediately after pushing the machine, re- engage the
brake lever to prevent a roll hazard.
NOTE: When brake lever is disengaged, the propel will
be disabled and a fault will be detected until lever is
re-engaged.
FOR SAFETY: When servicing machine, do not
push the machine on inclines with brake disabled.