Tennant T600 EE, Руководство оператора

Страница: 17 / 41

OPERATION
Tennant T600 EE (04-2018)
17
PRESET ZONE CONTROL BUTTONS
Use the zone control buttons to preset up to three
zones with different solution flow rates, brush
pressures, scrub speeds and scrub modes (Figure 28).
Zone 1 = Preset Zone Control Button 1
Zone 2 = Preset Zone Control Button 2
Zone 3 = Preset Zone Control Buttons 1 & 2
The zone control buttons are factory preset for different
scrubbing applications. A green LED in the corner will
turn on when activated. To use Zone 3, press zone
buttons 1 & 2 at the same time.
FIG. 28
To preset the zone control buttons for different
scrubbing applications, select the desired settings
from list below, then press and hold the zone
button until the green LED blinks three times to
save preset. To preset zone 3, press and hold
zone buttons 1 & 2 at the same time.
- Brush pressure setting
- Solution flow rate
- Quiet-Mode on or off
- Maximum scrub speed
(See Supervisor Controls)
SERVICE INDICATOR
When the machine or on-board battery charger detects
a fault, the service indicator will light up and begin
flashing (Figure 29). The battery discharge indicator
lights will also flash a fault code. See SERVICE
INDICATOR CODES to diagnose machine fault.
FIG. 29
BATTERY DISCHARGE INDICATOR
The battery discharge indicator (BDI) displays the
charge level of the batteries while the machine is
operating. When the batteries are fully charged, all five
indicators are lit (Figure 30). When the discharge level
reaches the red light, stop scrubbing and recharge the
batteries. When the red light begins to flash, the scrub
function will be disabled to protect the batteries from
total discharge. The machine will still propel when the
red light is flashing. This will allow user to transport the
machine to the charging station.
FIG. 30