Tennant 443C, Руководство оператора

Страница: 10 / 24

OPERATION
443C MM294 (5–92)
8
SQUEEGEE HEIGHT ADJUSTMENT RING
The squeegee height adjustment ring adjusts the
height of the front and back sets of squeegees
located on the scrub head. The adjustment ring is
located at the top of the scrub head. Turning the
adjustment ring adjusts the height and deflection
of the squeegees for proper water pickup. Turn
the adjustment ring to the left to increase
deflection, and to the right to decrease deflection.
PRE-OPERATION CHECKLIST
Check this list of items over before operating the
machine:
Check power cord for any wear or damage.
Do not operate machine with a damaged
cord.
TRANSPORTING MACHINE
To move the machine from one place to another,
raise the scrub head with the scrub head lift lever.
This makes maneuvering the machine easier.
When the machine is sitting and not being used,
raise the scrub head. This prevents the brush
from getting a flat spot. To raise the scrub head,
step on the scrub head lift lever until it locks into
position. To lower the scrub head, pull up on the
scrub head lift lever with the toe of your shoe.
A
06210
RAISING THE SCRUB HEAD
A. Scrub Head Lift Lever
FILLING THE SOLUTION TANK
1. Unplug the machine and move the machine
next to a water source.
WARNING: Hazardous Voltage. Shock
Or Electrocution Can Result. Unplug
Power Cord Before Working On Machine.
2. Remove the solution tank cover, letting it
hang on the side of the machine.
3. Using a clean bucket or hose, partially fill the
tank with hot water through the fill opening.
B
A
06215
FILLING THE SOLUTION TANK
A. Fill Opening
B. Solution Tank
ATTENTION: Do not use water hotter than
140
F (60 C) in the solution tank or tank
damage may occur.
4. Pour the specified amount of detergent into
the solution tank. Use TENNANT detergents
for best results. Do not use more detergent
than is recommended for the job. Powdered
detergents are not recommended.
WARNING: Flammable Materials Can
Cause An Explosion Or Fire. Do Not
Use Flammable Materials In Solution Tank.
5. Fill the solution tank with water up to the
bottom link of the chain hanging inside the
tank. DO NOT OVERFILL or damage to the
vacuum motor may occur.
B
A
06217
FILL LEVEL OF SOLUTION TANK
A. Fill Opening
B. Bottom Of Fill Chain