Operating temperature:
14 to 122°F (-10 to 50°C)
Humidity:
0 to 90% RH (non-condensing)
Insulation:
20M ohms min. (500VDC)
Breakdown:
2000V (AC), 50/60Hz, 1 minute
Vibration:
10–55 Hz, amplitude 1mm
Shock:
200m/s² (20g)
Moldings:
Flame retardant polycarbonate
Dimensions:
H: 3.75” (96mm) x W: 3.75” (96mm)
Depth behind panel: 2.07” (53mm)
Weight:
4 oz. (110g)
4. Installation
Dangerous voltage capable of causing death can be present in this instrument. Before installation or beginning any
troubleshooting procedures, the power to all equipment must be switched off and isolated. Units suspected of being
faulty must be disconnected and removed to a properly equipped workshop for testing and repair. Component
replacement and internal adjustments must be made by a qualified maintenance person only.
To minimize the possibility of fire or shock hazards, do not expose this instrument to rain or excessive moisture.
Do not use this instrument in areas under hazardous conditions such as excessive shock, vibration, dirt, moisture,
corrosive gases, or oil. The ambient temperature of the areas should not exceed the maximum rating specified.
4–1 Unpacking
Upon receipt of the shipment, remove the unit from the carton and inspect the unit for shipping damage. If there is any
damage due to transit, report the damage and file a claim with the carrier.
Write down the model number, serial number, and date code for future reference when corresponding with our service
center. The serial number (S/N) and date code (D/C) are labeled on the box and the housing of the controller.
4–2 Mounting
Make the panel cutout to fit the dimensions shown in figure 4.1.
Remove both mounting clamps and insert the controller into the panel cutout. Reinstall the mounting clamps. Gently
tighten the screws in the clamp until the controller front panel fits snugly in the cutout.
6
Figure .1 Mounting Dimensions
Figure 4.1 Mounting Dimensions
3.6"
(92mm)
3.6"
(92mm)
Panel cutout
2.07"
(53 mm)
Panel
