TEMA TELECOMUNICAZIONI SRL
Doorphone AA-514
MAS-AA514-REV03EN
Page 23 of 56
COMPLETE outdoor BOX (Accessory option AA-517-S)
The complete box is a cover that completely houses the
AA-514 system, both the front panel which is protected
as using the AA-517-T shield, and also the plastic rear
box of the system.
Using the accessory AA-517-S it is no longer necessary
to recess the rear plastic box of the system. The entire
system will be housed in the metal box AA-517-S and
will be on the surface of the wall.
The complete box, unlike the other two previously
described accessories, presents a radically different mode of assembly. The tubes with electrical cables for the
system should not be taken to be flushed plastic box but directly to one of the holes on the back (case with cables
not visible) or face down box complete (case of exposed wires).
Take the box from its packaging and place it on a work surface.
•
Remove by unscrewing the two black screws "A" on the right side that secure the front flat aluminum frame
"CF" .
•
Open with thumbs the sides of the box so that the flat frame may be removed or left pull down without
producing unsightly streaks on aluminum sides of the box (it is in fact to be avoided to extract or reassemble
the plastic back with flat frame set yet as if the frame foot down, one of the sides may be indelibly scratched).
•
You must then remove the 4 smaller screws "B" on the bottom of the back plastic "FP" to be able to pull out of
the complete box with aluminum cover which will be first fitted to the wall or on the surface scheduled
installation.
•
Open the holes "C" that you want to use for securing the "SM" box to the wall with the help of a tool that
pushes away the preprinted material that covers every single hole to be released.
•
Also open the "D" holes that you want to use for the passage of cables in the same manner.
•
Place the metal box directly on the wall to mark the holes to be made for fixing it. Run on the wall drilling for the
provided fixing anchors, finally place together with the box and tighten the screws of the anchor to secure it to
the wall.
•
Having previously defined the openings for cable entry on the box, open the corresponding preprinted "E" holes
also on the plastic back.
•
Screw the four "B" screws that mount the plastic back "FP" to the metal box "SM" to fix it inside the metal cover
and then re-create the basis for holding the front panel of the system.
•
Replace the front "CF" flat metal frame securing it with the two screws "A" on the right.
•
Proceed to connect the cables to the system board (see the connection section).
For the closing of the system after the cable connection, support the front aluminum frame aligning the two
transparent plastic plugs on their insertion holes on the left side of the flush plastic box, gently push it until it stops,
turn then around the front to close the box and secure with the two special screws planned for this purpose.
Ensure that the panel rests firmly on the wall or on its aluminum frame and check that the cables are properly
seated and not get caught between the front panel and the rear box. At the end cover the screws with the special
plastic inserts supplied with making just slip into their seats.
A
B
B
C
D
CF
FP
FP
SM
SM
E
