Example: Assume that your SX5 is connected to a PBX on extension 123. Now assume that you
want to be able to connect to any extension (i.e. 858) when you call the SX5 on the GSM network.
1. Make sure you are in Extension Mode by entering
#
*
108
*
1 #
from a DTMF phone
connected to the trunk side connector.
2. Enable Two-Stage Dialing by pressing
#
*
109
*
1 #
from the same DTMF phone connected
to the trunk side connector.
3. When the SX5 receives a call, it will automatically answer the call, then present a dial tone.
4. When you hear a dial tone, enter the extension you wish to call (858).
5. The far end caller (the person who called the SX5) will hear whatever the PBX presents after
you dialed the extension number.
Phonecell
®
SX5 GSM
23
User Manual
PBX Command Summary
Mode/Option
Command
Result
Change to trunk Mode
# * 108 * 2 #
Enables the SX5 Trunk
Mode.
NOTE: this is the default
mode for the SX5 PBX
option.
Change to Extension Mode
# * 108 * 1 #
Enables the SX5 Extension
Mode.
Enable Auto-route
# * 108 * 0 #
Enables the SX5 to Auto-
Route to an extension when
in Extension Mode.
Incoming calls tot he SX5
will be routed to the Auto-
Route Extension Number
automatically. This setting
disables two-stage dialing.
Auto-Route Extension
Number
# * 110 * <extension> #
Sets the extension number
that will be called when
Auto-Route is enabled.
Enable Two-Stage Dialing
# * 109 * 1 #
Disables Auto-Route and
enables two-stage
dialing.Callers will be able
to dial any extension within
the PBX. This is the default
mode.
Enable Disconnect Tone
Detection
See Disconnect Detect
Setup table on page 22
Disable Disconnect Tone
Detection
# * 111 * 0 #
Disables the detection of a
DTMF tone for disconnec-
tion by the PBX. This is the
default mode.
