Appendix 4: Programming Quick Reference
To Enable Remote Programming (On-Site):
•
Set front panel switch to PROGRAM until the green light flashes quickly.
•
Call the M-106 using a DTMF phone. When it responds with 3 beeps, you
are in program mode. Enter:
*98*1#
•
To activate security code for User 1, enter: *1*1*NN...N#*1*1*NN...N#
where:
NN...N may be 3 to 10 digits
•
Press # # and hang up. The unit can now be programmed remotely.
•
Press the front panel switch to READY until the green light flashes.
To Enter Programming Mode:
On-Site Programming
Complete the two steps below if you are on site or can have someone else on
site assist you. If not, see the Remote Programming instructions.
•
Set front panel switch to PROGRAM until the green light flashes quickly.
•
Call the unit from a DTMF telephone. When the M-106E responds with 3
beeps, you are in program mode.
Remote Programming (Password Access Enabled)
•
Call unit using a DTMF telephone.
•
When you hear an answer tone, enter the User 1 password, followed by #.
•
When the M-106E responds with 3 beeps, you are in program mode.
Remote Programming (Password Access Disabled)
•
Call the M-106E using a DTMF telephone. When you hear dial tone, enter
programming access code (default #*).
•
When dial tone ends and answer tone is heard, enter the User 1 password,
followed by #. When the M-106E responds with 3 beeps, you are in
programming mode.
•
When you finish programming, either enter the disconnect control code
(default # #) and hang up or enter the reseize control code (default **) to
place a call through the unit.
M-106E Reference Manual
Page 54
