Step 4: Enable remote programming
•
Enter the command:
∗
98
∗
1#
•
You will hear three beeps if the command was entered correctly.
Step 5: Assign system administrator password
•
Enter the following command (note that the security code for User 1 must
be entered twice, as shown):
∗
1
∗
1
∗
NN...N#
∗
1
∗
1
∗
NN...N#
where:
NN...N is the password (3 to 10 digits).
•
Listen for three beeps to confirm that the password is accepted.
Step 6: Verify password
•
Enter the command:
∗
77
∗
1
∗
1#
•
Listen for a voice and tone response in the following format: “one” beep
“NN...N” beep beep beep
Step 7: Disconnect
•
Enter the disconnect control code (default # #), then hang up. (The second #
must be entered within 2 seconds of the first.)
Note:
If you do not enter the disconnect control code (default # #) before you
hang up, the unit will automatically disconnect after a time delay.
However, routinely entering # # before hanging up avoids a wait time for a
forced disconnect before you can access the unit again.
Step 8: Access unit for programming
•
When you are ready to begin programming, dial the M-106E telephone
number. You will hear dial tone from the outgoing line.
Step 9: Enter password
•
Enter the program access control code (default #
∗).
(Enter the
∗
within the
programmed interdigit time. This applies to all 2-character commands: # #,
∗∗, ∗
#, and #
∗
when you are not in programming mode
.)
•
Wait for the dial tone to stop. You will hear a two-second tone indicating
the unit is ready to receive a password.
Chapter 5: Programming the M-106E
106E-101, Issue 1
Page 23
