Step 4: Connect outgoing line
•
Connect the outgoing telephone line to the OUT jack on the back of the
M-106E.
Step 5: Determine if user timeout required
•
Determine whether the timeout option is to be used to limit the length of
each user session. Write in that time (1-99 minutes or 0 if no timeout is
required) in Step 10.
Step 6: Determine password
•
Determine the password (3 to 10 digits) and fill in the blank space in Step 8.
Step 7: Enable password access
•
Press the front panel switch to PROGRAM until the green light flashes
quickly. From a convenient location, dial the M-106E telephone number.
When the unit answers (you will hear three beeps), enter the following
command to enable password access:
∗
15
∗
1 #
•
Listen for three beeps to confirm that password access is enabled.
Step 8: Assign User 2 password
•
Enter the following command (the blank is the user password as
determined in Step 7):
∗
1
∗
2
∗
#
•
You have just assigned a password to User number 2. You will hear three
beeps if the command was entered correctly. If you hear error tone, redial
the command making sure you include the
∗
and # digits as shown.
Notes:
(a) the unit will not respond until it receives the #
(b) If you misdial and have not yet entered a #
,
cancel the entry by dialing
000# and listen for error tone.
(c) Passwords may not end with 000.
Step 9: Verify password
•
Verify the password by dialing the following:
∗
77
∗
1
∗
2#
•
The unit will provide a voice response in the following format: “two” beep
<password> beep beep beep
Chapter 4: Installation and Basic Setup
106E-101, Issue 1
Page 17
