Chapter 5: Programming the M-106E
This chapter provides information needed to adjust the M-106E options.
You will normally program the M-106E by dialing the unit from a pushbutton
telephone and entering a password. Before you can do this, however, you will
have to perform the initial steps described below.
Whether or not you will require passwords to use the M-106E, you must
assign at least one password
before the unit can be accessed for remote
programming. The M-106E recognizes “User 1” as the programming or system
administration password.
Notes:
(1) When you access programming mode, the green light on the front
panel will flash.
(2) Calls will be disconnected whenever two minutes elapse without entry
of a digit.
The M-106E installer may already have assigned a password to “User 2”. You
can determine what, if any, programming has been done on your unit by using
Function 77.
Initial Steps
Step 1: Determine options to be set
•
The telephone number of the M-106E___________________________
•
Will you require users to enter a password? Yes
No
•
Do you want any of your users to be disconnected from the M-106E after
exceeding a time limit? Yes
No
Step 2: (optional) Fill out planning worksheets
•
If you answered “Yes” to any of the above, you may find it helpful to use
the planning worksheets in Appendix 3 to list the passwords and timeout
values to be assigned to each user number.
•
Do any other options need to be set to something other than the Default?
Use the worksheet in Appendix 3, if you wish, to list the changes.
•
To set up the unit for remote programming, see Remote Programming.
M-106E Reference Manual
Page 20
