TP-8/16/24/32/64S User Manual Version No.: V1.2
- 73 -
Parameter 1 is the MG domain name, and parameter 2 is the MG port number (optional). The max
domain name bit is 255, and port number ranges from 0
～
65535.
Command to set MGC domain name and port protocol_ep1> mgc {parameter1} [parameter2]
Its usage is the same as the “mg” command.
Command for setting standby MGC domain name and port
protocol_ep1> mgc2 {parameter1} [parameter2]
or
protocol_ep1> mgc3 {parameter1} [parameter2]
Its usage is the same as the “mg” command.
Command of H.248 permission mode setting
protocol_ep1> trans_type {parameter}
The parameter is only “tcp” or “udp”.
Command for setting H.248 signaling abbrev-mode
protocol > sig_ab_mode {parameter}
The parameter is only “enable” or “disable”. “enable” means to open it, and “disable” means to close
it.
Command for setting H.248 temporary endpoint
protocol > ephterm
The command is set by mode of interaction, it does not need any parameter. After carrying out the
command, CLI will require users to set relevant parameters. Direct buttoning of the enter key by users
will keep the original set value, and buttoning “Ctrl
＋
C” can cancel the settings. For instance:
protocol_ep1> ephterm
Ephterm Prefixion [RTP/]:
Start NO. [0]:
Ephterm Max Number [10000]:
Ephterm Step [1]:
Ephterm Name same length [n] (y/n)?
Command to set H.248 command re-sending time
protocol_ep1> resend_time {parameter}
The parameter is the time value of resent command, and unit is second.
MGC platform setting command of H.248
Interaction setting mode
protocol_ep1> mgcmode
After only entering “mgcmode” command, the command will inquire users about the MGC platform
