TP-8/16/24/32/64S User Manual Version No.: V1.2
- 72 -
network> ntp
The command is set by mode of interaction, it does not need any parameter. After performing the
command, CLI will show the on-off state of current NTP client service, and then inquire users whether
to open or close it. Users can choose “disable” or directly button enter key to get out of the setting, or
else, CLI will show the value set for the address of current NTP server, and inquire users about the
server address that is going to be reset. For instance:
Ntp service is disabled.
Enable Ntpserver? [y/n]: y
Current Ntp IP or domain name is "www.asia.pool.ntp.org".Please
input a new Ntp IP or domain name.
NTPSERVER (Enter to pass):
Ntp IP or domain name is not changed.
Buttoning “Ctrl
＋
C” during setting can give up setting.
Exit command
network> exit [parameter]
Help command
network> help [parameter]
6.2.3 Protocol-related Parameter Setting Command Set
It will immediately go into the protocol-related parameter setting content once input “protocol”
command in the root command layer, see below:
＃
protocol
Port name setting command
protocol_ep1> ep_name {parameter}
The parameter is the port name, and the max bit is 255.
Command to set heartbeat mode and interval protocol_ep1> heartbeat
The command is set by mode of interaction, it has no need of any parameter. Buttoning enter key will
remind you whether to close heartbeat mode or which heartbeat mode should be chosen. Choosing
“disable” or directly buttoning enter key will automatically get out of settings; choosing “[2]MGC” or
“[3]MG” will let system require to set heartbeat interval and heartbeat survival time, and choosing
“[3]GC” mode will inquire whether to send heartbeat package. Heartbeat interval’s value ranges from
1~65535, and its survival time’s value ranges from 1~255, unit is ms.
Command to set MG domain name and port
protocol_ep1> mg {parameter1} [parameter2]