Eye
III+
I
nstallation Guide
Page 21
System Configuration and Installation
Transmitter Installation
Step 1:
Plug the telephone cable into the modem's
LINE
connector.
Step 2:
Plug the other end into the telephone wall jack.
Step 3:
Plug the modem power cable into the modem power connector.
Step 4
: Plug the male end of the serial cable into the female connector on the modem's rear panel.
Afterwards, plug the other female end of the serial cable into the modem port on the
Eye
III+
transmitter's rear panel.
Tighten the retaining screws to ensure proper connection.
Step 5
: Plug one end of the
BNC
cable into the
VIDEO OUTPUT
of the
CCD
camera, then plug the
other end to the
Eye
III+
transmitter 's
VIDEO INPUT
connector (
CH1
preferred)
If more than one camera is installed, plug the
BNC
cables to the
Eye
III+
transmitter
CH2
to
CH4/8/16
sequentially (For 2/4/8/16 Cam model only).
Step 6:
Connect alarm sensor to the corresponding pins of the
ALARM & SWITCH
port, if necessary.
(For the pin assignment of the ALARM port, please refer to section 2,
Alarm Definition
)..
Step 7:
Plug the modem power supply into a wall let and power on the modem.
Step 8:
Plug the round end of the A.C. adaptor into the socket marked
$#%&'
on the
Eye
III+
transmitter. (Note: transmitter can support 9V D.C. to 12V D.C. supply voltage)
Step 9:
Plug the A.C. adapter to A.C. power source to power on the
Eye
III+
transmitter. The
modem's LEDs (
ATA, TR
) and
Eye
III+
transmitter 's LED on the front panel should
light up.
Step 10:
You may now use the
Eye
III+
Reception Software
to connect to the transmitter. For
the instructions of using the software, please refer to the
Eye
III+
Reception
Software
User Guide.
Support 1/2/4/8/16
Video Sources
Содержание VT3-16BA
Страница 1: ...Transmission Unit Installation Guide...
Страница 7: ......