Genie Nano cameras store their configuration settings (I/O, shutter speed, white
balance) in memory (EEPROM). iNspect Express overrides these settings according to
the solution file, whereas Sherlock loads them from the camera or a stored
configuration file during program initialization. You can change these parameters and
save them on the camera and/or a configuration file using the Sapera CamExpert utility.
This does not apply to the PIC-2592 camera. Refer to the PIC-2592 Quick Start Guide.
You can configure the camera to load either your saved settings, or the factory settings,
at power up. The preferred method is to save your settings to both the camera and a
configuration file. Sherlock can load a configuration file at startup. If multiple
configurations are needed, you can save them to different camera configuration files.
Some example configuration files are included on the GV 400.
Note:
Changes to the camera settings are temporary, unless saved to the
camera memory or to a configuration file.
The Sapera CamExpert Utility
19
GV 400 Installation
Version 1.3; 2020-5-14
