Teledyne Falcon4 57M, Руководство пользователя, Страница: 49 / 68

Appendix A: GenICam Commands Falcon 4 Camera User's Manual
•
47
I / O Control Category
The camera’s I / O controls, as shown by CamExpert, group features used to configure external
inputs and acquisition actions based on those inputs, plus camera output signals to other devices.
I/O Controls Feature Descriptions
The following table describes these parameters along with their view attribute.
Display Name Feature & Values Description Standard
& View
Trigger Selector TriggerSelector Displays the type of trigger to configure with the various
Trigger features. <RO>
Beginner
FrameStart FrameStart Selects a trigger starting the capture of a single frame.
Trigger Mode TriggerMode Enables and disables external frame trigger.
Beginner
Off Off Use internal trigger.
On On Use external trigger
Trigger Source TriggerSource Specifies the internal signal or input line to use as the
trigger source. <RO>
The trigger mode must be set to On.
Beginner
Software Software CLHS Trigger message from the frame grabber
LinkTrigger0 LinkTrigger0 General Purpose Input Line 1
Line1 Line1 General Purpose Input Line 2
Line2 Line2 Software trigger through the TriggerSoftware command
Software Trigger TriggerSoftware Generate an internal trigger. Available when the trigger
mode is enabled and the trigger source is equal to
Software.
Beginner
Trigger Delay TriggerDelay Specifies the delay in microseconds to apply after the
trigger reception before activating it. Possible values are:
0 - 281474976710655 µs
Beginner
LineSelector LineSelector Selects the logical line of the device to configure. Beginner
General Purpose Input 1 Line1 General Purpose Input 1
General Purpose Input 2 Line2 General Purpose Input 2
General Purpose Output 1 Line3 General Purpose Output 1
General Purpose Output 1 Line4 General Purpose Output 1
Line Mode LineMode Returns if the selected physical pin is used as an input or
output signal. <RO>
Beginner
Input Input The selected physical pin is used as an input.
Output Output The selected physical pin is used as an output.
Line Pinout linePinAssociation Gets the physical pin location associated with the logical
line. The H1 prefix refers to the Hirose Power and input
cable (see Figure 6). <RO>
DFNC
Beginner
H1_Pin6Pos_Pin5Neg H1_Pin6Pos_Pin5Neg General Purpose Input 1:
Hirose Pin 6 Positive, Pin 5 Negative.
H1_Pin11Pos_Pin12Neg H1_Pin11Pos_Pin12Neg General Purpose Input 2:
Hirose Pin 11 Positive, Pin 12 Negative.
H1_Pin3_Pin4 H1_Pin3_Pin4 General Purpose Output 1:
Hirose Pin 3 , Pin 4.
Preliminary