Teledyne Lecroy WaveJet Touch, Руководство по началу работы

Страница: 37 / 40

REFERENCE
33
WaveJet Touch Getting Started Guide
Safety Compliance
EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The oscilloscope meets intent of EC Directive 2014/35/EU for Product
Safety. Compliance was demonstrated to the following specifications as
listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment
for measurement, control, and laboratory use – Part 2-030: Particular
requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following
limits put forth by these standards:
•
Mains Supply Connector: OverVoltage Category II, instrument intended
to be supplied from the building wiring at utilization points (socket
outlets and similar).
•
Measuring Circuit Terminals: No rated measurement category.
Terminals not intended to be connected directly to the mains supply.
•
Unit: Pollution Degree 2, operating environment where normally only dry,
non-conductive pollution occurs. Temporary conductivity caused by
condensation should be expected.
U.S. NATIONALLY RECOGNIZED AGENCY CERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears the UL Listing Mark:
UL 61010-1 Third Edition – Safety standard for electrical measuring and
test equipment.
CANADIAN CERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears the cUL Listing Mark:
CAN/CSA-C22.2 No. 61010-1-12. Safety requirements for electrical
equipment for measurement, control and laboratory use.
Environmental Compliance
END-OF-LIFE HANDLING
The instrument is marked with this symbol to indicate that it
complies with the applicable European Union requirements
to Directives 2012/19/EU and 2013/56/EU on Waste
Electrical and Electronic Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling
regulations that vary by country and region. Many countries prohibit the
disposal of waste electronic equipment in standard waste receptacles.
For more information about proper disposal and recycling of your
Teledyne LeCroy product, please visit teledynelecroy.com/recycle.
RESTRICTION OF HAZARDOUS SUBSTANCES (RoHS)
This instrument and its accessories conform to the 2011/65/EU RoHS2
Directive
ISO Certification
Manufactured under an ISO 9000 Registered Quality Management System.
Intellectual Property
All patents pertaining to the WaveJet Touch can be found on our
website at: teledynelecroy.com/patents.